Latch Plots Basics
Learn how to bring data into a plotting layout and chart it.
Create a new plotting layout
In the right sidebar click the + New Plot button.
This will open up a creation modal where you can give your layout a name, select start from a Blank Layout and then click create.
Bring data in
-
In the layout just created, click the + Table Display/Filter button in the middle of the screen.
-
At the top of the new table cell click Select table… → Select From Latch Data.
-
Upload this file CoCl2 vs control (condition).csv and select it in the file modal.
-
After selecting your file you will be able to preview the data in the Table Viewer cell.
Create a plot
-
In the Table Viewer cell click the Create Plot from the top left corner of the cell and select Volcano from the dropdown.
-
In the new Plot cell below make sure the left edit sidebar is open. You can open it by clicking the Pencil edit button on the left side of the cell.
-
In the Plot edit side bar for the X-Axis select the log2FoldChange column and for the Y-Axis select the pvalue column.
-
You have visualized your first data in Latch Plots!
Was this page helpful?